How to build and use a sluice for Gold Prospecting

Building a sluice for gold prospecting involves the following steps:

1. Gather materials: You will need wood, screws, nails, and mesh (such as hardware cloth or expanded metal) to build the sluice.
2. Cut the wood: Cut the wood to the desired length for the sluice. The standard length is around 3 feet, but it can be longer or shorter depending on your preference.
3. Assemble the frame: Use screws and nails to assemble the frame of the sluice. The frame should have a slight incline to allow the water to flow through it.
4. Attach the mesh: Use screws to attach the mesh to the bottom of the sluice. This will act as a filter to trap the gold.
5. Add riffles: Riffles are small ridges or barriers that are placed in the sluice to trap the gold. They can be made out of wood or plastic and are typically spaced about every 2 inches.

Using a sluice for gold prospecting involves the following steps:

1. Find a good spot: Look for a spot where there is a natural flow of water, such as a stream or river. This will provide the necessary water to wash the material through the sluice.
2. Dig up material: Dig up material from the stream bed or river bank and place it in the sluice.
3. Add water: Use a hose or bucket to add water to the sluice. The water will wash the material through the sluice and trap the gold in the riffles.
4. Check the riffles: After a few minutes, check the riffles for any gold that may have been trapped. Use a small brush or tweezers to remove any gold that you find.
5. Repeat: Repeat the process as necessary to find as much gold as possible.

Note: It's important to check the laws and regulations of your area before prospecting for gold. Some areas may require a permit or have specific restrictions on where you can prospect.